Yukai Li GMMan

Tamagotchi Paradise Sprite Format

Because Tamagotchi Paradise runs on hardware that does not include a hardware PPU, it uses a different, yet simpler format for storing sprites.

All data are to be read in little endian order.

Sprite package

The sprite package consists simply of a table of offsets and the sprite data

Tamagotchi Paradise Prongs Protocol

This document describes the protocol Tamagotchi Paradise uses to communicate with other units. It is split into two parts, the transport layer and the packet protocols.

TCP Transport Layer

Tamagotchi Paradise uses UART at 460800/8-N-1 and a protocol called TCP (not to be confused with the TCP in TCP/IP) to pass data between peers. The protocol

Dumping ROMs from TI CC2640R2F

Main flash

Memory address 0x0 to 0x1ffff. Dump over JTAG or built-in bootloader (if enabled).

Boot ROM

Memory address 0x10000000 to 0x1001cbff. Dump over JTAG or built-in bootloader.

RFCBITS @ `0x400821cc`

Values indicate bit mask.

0x00000001: boot type: 0 = with command, 1 = special boot

Boot with command

Command specified will be executed immediately after boot init (unverified), unless command is 0, which will result in a completely normal boot.

Special boot

0xe0000000: 7 = special request, otherwise execute code out of address specified by RFCBITS

Vital Bracelet BE Battle Logic

If you're looking for Vital Bracelet (Digital Monster, Digivice -V-, Characters, Vital Hero) battle logic, please see here.

Encounter and setup

Each character on a BEM has three encounter chance percentages: one for phase 1-4, one for phase 5-7, and one for phase 8. For Dims and VBMs, there is no

Building Xtra-PC Ultra from Source

Superseded by this repo. See wiki page for build instructions.

GPCE4 Test Program

Entry

Before powering on the MCU, raise TEST pin high, configure wait states, select the test to run, and configure any inputs.

Test mode selection

Determines whether MCU starts in test mode.

	#include <furi.h>
	#include <furi_hal.h>

	void test1_app_init();
	uint32_t test1_app();
	void test1_app_test();

	void test1_app_init() {
	printf("init\n");
	}

	// See https://aka.ms/new-console-template for more information
	using System.Text.RegularExpressions;

	string inFile = @"your_patch_file.c";
	string outDir = @"your_output_dir";

	Regex patternRegex = new Regex(@"; (.+?):\s+(\d+) (.*)");

	using StreamReader sr = File.OpenText(inFile);
	Directory.CreateDirectory(outDir);

	Note that the first one appears to be a story unlock password. Not sure what
	that means since I kind of skipped over the message box that displayed for it.
	Original page for that is at https://www.takaratomy-arts.co.jp/specials/dqdai-pa/pw/

	6B8HY 10xやくそう
	NUGBV 30xやくそう
	LBKWF 30xやくそう
	K5L2Z 30xやくそう
	YWVYC 30xやくそう
	VCGVU 30xやくそう