Screws tilt for klipper for a neptune 4 max

screwstilt.cfg

[screws_tilt_adjust]

#Positions below show x and y positions of each screw adjusted for position of the probe as per this documentation
screw1: 239, 189.55 #old value for x was 234.25
screw1_name: center point
screw2: 62.25, 13.55
screw2_name: front left screw
screw3: 416.25, 13.55
screw3_name: front right screw
screw4: 416.25, 189.55
screw4_name: side right screw
screw5: 416.25, 367.55
screw5_name: rear right screw 
screw6: 62.25, 367.55
screw6_name: rear left screw
screw7: 62.25, 189.55
screw7_name: side left screw

#Actual Screw positions
#screw1: 38, 34
#screw1_name: front left screw
#screw2: 392, 34
#screw2_name: front right screw
#screw3: 392, 210
#screw3_name: side right screw
#screw4: 392, 388
#screw4_name: rear right screw 
#screw5: 38, 388
#screw5_name: rear left screw
#screw6: 38, 210
#screw6_name: side left screw

horizontal_move_z: 10
speed: 10000
screw_thread: CW-M4 #measure the diameter of your adjustme