Create a template service file at /etc/systemd/system/[email protected]. The template parameter will correspond to the name
of target host:
[Unit]
Description=Setup a secure tunnel to %I
After=network.target
钟馗 liaozd
drmalex07
/ README-setup-tunnel-as-systemd-service.md
Last active
October 24, 2025 10:22
Setup a secure (SSH) tunnel as a systemd service. #systemd #ssh #ssh-tunnel #ssh-forward
kamermans
/ configure_docker0.sh
Last active
December 29, 2024 12:44
Change the IP subnet of Docker's docker0 interface
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| #!/bin/sh -e | |
| # | |
| # NOTE: Since Docker 1.10 (February 4, 2016), it has been possible to configure the | |
| # Docker daemon using a JSON config file. On Linux, this file is normally located at | |
| # /etc/docker/daemon.json. You should use this JSON config method if you are running | |
| # a version of Docker that is at least 1.10! | |
| # Here is an example configuration that sets the docker0 bridge IP to 192.168.254.1/24: | |
| # { | |
| # "bip": "192.168.254.1/24" | |
| # } |
