mbrgm

# This file contains pin mappings and reasonable defaults for Prusa i3 MK3S
# printers. It will work with MK3 (non-S) by selecting the alternative filament
# sensor. References to common community mods are included as well.
#
# Note: The Einsy boards sold by Prusa have defective firmware on the
# usb-to-serial chip that makes the boards unusable with Klipper through USB.
# While flashing Klipper firmware must be done over USB, the board can be used
# via serial with no additional modification.
#
# To use this config, the firmware should be compiled for the AVR atmega2560.

mbrgm

# xcode-build-bump.sh
# @desc Auto-increment the build number every time the project is run. 
# @usage
# 1. Select: your Target in Xcode
# 2. Select: Build Phases Tab
# 3. Select: Add Build Phase -> Add Run Script
# 4. Paste code below in to new "Run Script" section
# 5. Drag the "Run Script" below "Link Binaries With Libraries"
# 6. Insure that your starting build number is set to a whole integer and not a float (e.g. 1, not 1.0)