EverythingSmartHome

esphome:
  name: esp32-mic-speaker
  friendly_name: esp32-mic-speaker
  on_boot:
     - priority: -100
       then:
         - wait_until: api.connected
         - delay: 1s
         - if:
             condition:

wolph

light:
  - platform: neopixelbus
    type: GRB
    variant: WS2812
    pin: GPIO1
    num_leds: 1
    name: "NeoPixel 1"
    internal: true
  - platform: neopixelbus
    type: GRB

wess

; Ender 3 Custom Start G-code
M140 S{material_bed_temperature_layer_0} ; Set Heat Bed temperature
M190 S{material_bed_temperature_layer_0} ; Wait for Heat Bed temperature
M104 S160; start warming extruder to 160
G28 ; Home all axes
G29 ; Auto bed-level (BL-Touch)
G92 E0 ; Reset Extruder
M104 S{material_print_temperature_layer_0} ; Set Extruder temperature
G1 X0.1 Y20 Z0.3 F5000.0 ; Move to start position
M109 S{material_print_temperature_layer_0} ; Wait for Extruder temperature

wybiral

#include <BLEAdvertisedDevice.h>
#include <BLEDevice.h>
#include <BLEScan.h>

const int PIN = 2;
const int CUTOFF = -60;

void setup() {
  pinMode(PIN, OUTPUT);
  BLEDevice::init("");

frenck

Unbuntu is no longer support by the Home Assistant project.

The installation commands previous listed here, are not up 2 date, not recommended, not supported and, therefore, removed.