Gumstix overo on a way small silverlode. Booting first time with newly built 3.5.7 kernel.

gistfile1.txt

U-Boot SPL 2013.07 (Dec 30 2013 - 23:40:26)
i2c_write: pads on bus 0 probably not configured (status=0x10)
i2c_read (addr phase): pads on bus 0 probably not configured (status=0x10)
OMAP SD/MMC: 0
reading u-boot.img
reading u-boot.img


U-Boot 2013.07 (Dec 30 2013 - 23:40:26)

OMAP36XX/37XX-GP ES1.2, CPU-OPP2, L3-165MHz, Max CPU Clock 1 Ghz
Gumstix Overo board + LPDDR/NAND
I2C:   ready
DRAM:  512 MiB
NAND:  512 MiB
MMC:   OMAP SD/MMC: 0
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Board revision: 1
Direct connection on mmc2
No EEPROM on expansion board
Die ID #75ae00029ff800000154388302031027
Net:   smc911x-0
Warning: smc911x-0 using MAC address from net device

Hit any key to stop autoboot:  0 
mmc0 is current device
reading boot.scr
** Unable to read file boot.scr **
reading uEnv.txt
** Unable to read file uEnv.txt **
reading uImage
3471672 bytes read in 220 ms (15 MiB/s)
Booting from mmc ...
## Booting kernel from Legacy Image at 82000000 ...
   Image Name:   Linux-3.5.7
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    3471608 Bytes = 3.3 MiB
   Load Address: 80008000
   Entry Point:  80008000
   Verifying Checksum ... OK
   Loading Kernel Image ... OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.